SIZE GUIDE

FIND YOUR NECKLACE LENGTH

1. Measure and cut a piece of string, or use string/flexible tape, to the same length as the necklace you want.

2. Place it around your neck to see where it falls. Consider the size and shape of the pendant.

MEASURING YOUR WRIST

1. Use a tape measure, or if you do not have one, use a strip of paper, ribbon, or cord. Wrap it around your wrist, where you would normally wear your bracelet.

2. If you are using a strip of paper, ribbon, or cord. Mark the end of the strip and measure its length with a ruler. This is your wrist size.

3. Refer to the chart below to determine your wrist size and the recommended bracelet size, which is based on comfort fit. Depending on whether you prefer a snug fit, a comfort fit, or a loose fit, you may need to size up or down.

MEASURING YOUR FINGER

1. You can easily determine your own ring size using a measuring tape or a cord. To measure, simply place the cord (or the measuring tape) around your finger tightly. The cord ends should be marked.

2. Using a ruler, measure the marked cord to determine your ring size in circumference.

3. Compare it to the “finger circumference” on the ring size table. The image shows a measurement of approximately 5.2 cm, which can be rounded up to 5.3 or 5.25 cm.

Or measure with a ring (inner ring)

Place the ring on a ruler (centimeter side). Make sure it starts at 0 and you’re measuring the inside diameter, not the outside. Refer to the size chart below to determine your size.

To find the ring size, please check above size chart.